Wire Harness Manufacturing Division
Get a Quote

7-Pin Ribbon Cable with Tinned Tail

7-Pin Ribbon Cable with Tinned Tail
Technical Specifications
Part Description 1H/2511H-7P+UL2468#26-3C黑排 L=400MM
Customer Part No. R30072943
Drawing No. S007210128
Version B
Date 2018-05-22

Dimensions

ItemValue
Total harness length400±10 mm
H1 branch-out length23±2 mm
Tail twisted tinned length3.5±0.5 mm

Terminal Definition

ConnectorPinsWiring
H1 (2511H-7P N1020-9207 白色)7P3Mark 4Mark 5Mark(UL)
Twisted tinned tail33 loose tinned tips

Bill of Materials

No.Material SpecificationQtyUnit
12511H-7P (N1020-9207), white1PCS
22511T (172031-M2)3PCS
3UL2468 26AWG-3C black ribbon cable, tinned copper409mm

Process Requirements

1. Branch out 23±2mm at the H1 end, strip 2.5+0.5mm and crimp 2511T terminals; 2. Terminal-to-housing pull-out force must exceed 2Kg/F; 3. Continuity resistance below 2Ω; 4. Pin 5 must carry a UL mark (on the finished product the mark appears inverted); marking content on pins 3 and 4 is not specified; 5. Finished twisted tinned tail OD must be below 0.9mm.

Packaging

100 PCS per bundle; wrap the tinned tips with foam sheet then PE film, fold each bundle in half and tie with a cable tie, pack in a suitable carton.
Engineering Drawing
Engineering Drawing - 7-Pin Ribbon Cable with Tinned Tail

Product Introduction

This ribbon harness uses a white 2511H-7P housing at one end and bare tinned wire tails at the other, built from a black UL2468 ribbon cable. The tinned tails can be soldered directly to a board or inserted into a customer connector as required. It is a fixed internal connection lead for electronic equipment, with the ribbon keeping the pin sequence aligned from end to end.

Product Features

  • White 2511H-7P housing at one end
  • Tinned bare tails at the other end for soldering
  • Black UL2468 26AWG ribbon cable with tinned copper
  • Ribbon keeps the pin sequence aligned
  • Fixed lead length of about 409mm

Technical Specifications

  • Pin count: 3 active circuits in the ribbon
  • Wire: UL2468 26AWG 3-conductor black ribbon
  • Terminals: 2511T crimped terminals at the housing end
  • Tails: stripped and tinned for direct board connection
  • Testing: 100% continuity test on finished harnesses

Quality Assurance

We produce to customer drawings and samples, from prototype to volume production. All harnesses are continuity tested before delivery, and samples are checked against the approved drawing. Lead length and tail treatment can be adjusted for different equipment designs.

Get a Quote Back to List