JST EH Series Terminal|SEH-001T-P0.6 Crimp Terminal
Product Introduction
The JST EH series terminals are used for crimping wire ends in the 2.5mm pitch EH wire-to-board connection system. Common part numbers include SEH-001T-P0.6, SEH-003T-P0.6L, and SEH-002T-P0.6L. After crimping, the terminals are inserted into EHR housings and then mated with B2B-EH-A series board-end receptacles; the EH series is a low-profile wire-to-board connection.
Structure and Matching
The terminal consists of a crimping section, a long contact tab, and an anti-deformation structure. EH terminals have a longer strip length, which facilitates automatic crimping and shielded wire processing; terminals must be matched with EHR housings and EH connectors of the same series.
Selection Parameters
The table below lists typical structural items and rated values from JST's public catalog. Specific pin positions, plating, packaging, and compatible wire gauges are subject to the part number specification.
| Item | Parameter/Typical Value |
|---|---|
| Nominal Pitch | 2.5 mm |
| Component | Wire End Crimp Terminal |
| Compatible Housing | EHR-2 ... EHR-15 |
| Compatible Header | B2B-EH-A / S2B-EH |
| Applicable Wire Gauge | SEH-001T-P0.6: AWG30–22 |
| Applicable Wire Gauge | SEH-002T-P0.6L: AWG30–26 |
| Applicable Wire Gauge | SEH-003T-P0.6L: AWG32–28 |
| Rated Current/Voltage | 3 A (AWG22) / 250 V (Public Catalog Typical Value) |
| Plating/Packaging | Tin Plated, Reel, Confirm by Part Number |
Common Part Number Examples
The following part numbers are for searching and inquiry communication only and do not represent the entire supply range; actual supply should be verified against drawings, BOM, or samples.
| Part Number Example | Description | Compatible / Pin Position |
|---|---|---|
| SEH-001T-P0.6 | EH crimp terminal, AWG30–22, tin-plated | EHR housing / EH pin socket |
| SEH-002T-P0.6L | EH crimp terminal, AWG30–26, tin-plated | EHR housing / EH pin socket |
| SEH-003T-P0.6L | EH crimp terminal, AWG32–28, tin-plated | EHR housing / EH pin socket |
| Terminals by part number | Other plating or packaging according to drawings/BOM | Same series housing |
Application Scenarios
EH terminals are used for 2.5mm wire-to-board connections in appliances, industrial controls, and power boards.
- Internal wiring of appliance control boards
- Signal connections in industrial control boards
- Interconnection between power boards and load boards
Inquiry and Replacement
For inquiries, please provide the terminal part number, wire gauge, insulation outer diameter, plating, packaging, and quantity; for replacements, first verify the crimp range, stripping length, and compatibility of housing and pin socket.
Related links: JST EH Series Page; JST Series Connector Categories; Agency Part Number Index; Terminal/Housing Selection Guide.