PLC control cabinet harness: layout, shielding and first-article checks
Cabinet layout: fix zones and routing first
Divide the cabinet into power, signal and communication zones, and route power and low-level signals separately. Confirm the mounting plate size, door hinge position, cooling path and maintenance clearance before deciding where the harness enters, exits, bends and is fixed. Building the harness before the layout is frozen usually leads to rework in length and bend radius.
Segmentation and marking: avoid one large cabinet-wide harness
Split the harness by function, station or module, and mark length, terminals, connectors, sleeving and tie points for each section. Wire numbers, circuit numbers and cabinet numbers should match the wiring table, with labels facing the maintenance side. Clear segmentation speeds both assembly and troubleshooting.
Shielding and grounding: treat signal and power routes separately
Choose shielded or twisted-pair constructions for encoder, analogue and communication lines according to the signal type. Terminate the shield at one point on the controller side as shown on the drawing. Do not share a route between power and signal cables, and crimp ground leads independently instead of relying on cabinet bonding. Put the shielding and grounding method on the drawing before production.
Crimping and first article: confirm before the batch
Confirm crimp height and pull force for the actual wire and terminal combination. The first article checks wire sequence, length, terminal orientation, locking, labels, continuity and insulation. Only then run the batch, and retain crimp settings, sample and inspection results as a reference for the next wire or material change.
RFQ inputs: drawings, lists and test requirements
For a quote, provide the schematic or wiring table, cabinet layout, connector list, wire specification, quantity, lead time and test requirements. If drawings are not available, send a sample, wiring photos and interface definition. Better inputs mean fewer loops in sampling and quoting. See custom wire harness manufacturing for scope.