Process scope: what heat-shrink tubing can solve

Heat-shrink tubing insulates and mechanically protects joints, terminal tails and branch nodes, carries marking and seals ends; it does not replace the connector's own sealing or potting. Before the first piece, confirm the size of the protected object, the continuous operating temperature, the heat margin of nearby wires, and that the shrunk tube will not cover latches, contacts, heat-dissipating surfaces or service access.

Selection and size matching: shrink ratio, inner diameter and wall thickness

Select the tube by harness outer diameter, shrink ratio and wall thickness after shrinking: the inner diameter must slip on easily, and after shrinking it must grip without squeezing out excessive adhesive. Use adhesive-lined tube for ends that need water sealing and clear tube where the internal structure must remain visible. The material temperature rating must cover the actual duty and the heating process, not just room-temperature insulation.

Positioning and installation: what to cover and what to avoid

Position the tube to cover the crimp tail, weld or branch node, with both ends overlapping the adjacent insulation; it must not press on terminal latches, contacts or the connector mating face. Set the cut length from the node length and overlap, keep the cut square, and avoid scratching insulation or breaking fine wires while inserting.

Heating and shrinking: temperature window and movement

Use hot air or dedicated heating equipment and set the temperature window from the tube specification and process validation. Move evenly around the circumference and advance from one end to the other to drive air out and avoid local overheating. Stop and adjust if scorch marks, bubbles, incomplete shrinkage or adhesive overflow appear; never shrink with an open flame or heat nearby harnesses.

Inspection and batch release: appearance, wall and seal

The first piece must be fully shrunk, smooth, free of wrinkles, bubbles and scorch marks, sealed at the ends and within wall-thickness requirements; adhesive-lined tube also needs a continuous adhesive layer. Patrol inspection follows the control plan. If incomplete shrinkage, cracking, scorch or poor sealing appears, isolate the batch and trace the tube lot, heating equipment and operating parameters. For custom assemblies, see custom wire harness manufacturing.

Get a Quote Back to List