Process scope: what cutting and stripping must hold

Cut length, strip length, cut angle and strand integrity are fixed before crimping. Confirm the wire type, gauge, insulation and half-strip requirement from the drawing; do not let the operator guess from a sample.

Length and tolerance: set from the drawing and harness length

Program cut length and strip length with the drawing tolerance and add compensation where the next process needs it. Check the first piece against the wiring table, then audit at each reel change; a length drift shows up when the harness will not dress into its sleeve.

Conductor damage: cuts, nicks and lost strands

Blade gap, blade type, clamping force and wire straightness decide whether strands are damaged. A nicked conductor may pass continuity and fail under vibration. Set the blade gap by wire gauge, inspect the strip window under magnification and record any strand loss.

Blades and equipment: life, inspection and changeover

Blade wear starts before the cut looks visibly bad. Count strokes, inspect the blade edge and strip window at a fixed interval, and change the blade as a set. After changeover, re-run the first piece and update the machine recipe.

First piece and batch release: how to judge

Release the first piece only after cut length, strip length, strand condition and pull-off force meet the drawing. Keep the sample, blade counter and recipe version with the batch record. For custom assemblies, see custom wire harness manufacturing.

Get a Quote Back to List