Cable tie and clip fixing process for wire harnesses: branch nodes, tie direction, clip installation and batch inspection
Process boundary: what fixing covers and what it does not
This article covers the fixing operation at the assembly bench: the already crimped, inserted and latched harness is routed and tied, and branches are fixed to body or equipment mounting points with clips or brackets. It does not cover connector selection, terminal crimp parameters or electrical testing, and it does not replace the drawing's definition of fixing points. The process document only defines how to fix, where to fix and how to inspect after fixing; the actual mounting position follows the drawing and process card.
Branch nodes: routing, split angle and allowance
Start at the branch node and check the routing: the main run follows the routing channel, the branch leaves the node, and the split angle is set by the drawing and by the available space in the vehicle or equipment so that the branch does not kink sharply at the node. Leave enough length at the node for later mating and service; the allowance follows the process card, not a visual guess. After the branch leaves the main run, fix it temporarily and confirm that the routing does not interfere with moving parts, heat sources or sharp edges before final tying.
Tie wrapping: position, direction, tension and tail trimming
Tie positions follow the spacing and nodes marked on the process card, and tie heads point in the same direction so they are easy to inspect and do not rub the adjacent harness. Gather the harness until it sits naturally, without indenting the conductors or leaving loose loops. After the tie passes through its head, tension it as specified on the process card, then cut the excess tail with a dedicated cutter so the cut is flush and has no sharp point. Trim the tail away from hand-reachable areas and adjacent insulation.
Clip installation: slot, clip orientation and panel match
Before installing a clip, confirm that the clip specification matches the slot, that the clip orientation matches the drawing, and that the clip body has no crack, deformation or missing feature. Align the clip with the slot, press it in the designed direction and stop when the seating feedback is heard or felt. Do not use a cable tie in place of a clip, and do not force a clip into a mismatched hole. For bracket-mounted points, fit the bracket before the harness, keep the bracket in contact with the panel, and tighten screws in the sequence and torque given on the process card.
Inspection and batch: appearance, retention, tail trim and traceability
Inspect every fixed assembly: tie position and direction, any indentation on the harness, flush tail trim, clip seating and looseness, and presence of all bracket screws. Verify retention according to the sampling plan; isolate the assembly and trace its batch when looseness, pull-out or a sharp tail is found. Record the station, batch, sampling result and disposition. For rework, replace only the damaged tie or clip and never reuse a tie that has already been cut. More harness fixing and assembly requirements are covered in custom harness manufacturing.