Process scope: what tape wrapping must hold

Tape type, width, wrap length, layer count, overlap and branch fixing method are fixed before the first piece. Confirm from the drawing and customer specification which locations use tape and which use ties or sleeves; do not let the operator add wrap by habit.

Layers and overlap: set from the drawing

Layer count and overlap width come from the drawing or customer specification, not from feel. For half-lap wrapping, keep the tape continuous and anchor both the start and the finish; where abrasion or insulation is critical, add the specified layers and mark them.

Direction and branches: how the wrap runs

Wrap along the harness run with the tape face outward, avoiding reverse winding and an open edge facing up. Fix the main run before finishing a branch, keep the bend radius at turns, and use ties, clips or sleeves at moving or specified locations.

Tension and appearance: lift, wrinkles and exposed conductor

Keep tape tension even; too tight narrows the tape and too loose lets it lift. Finish on the tape surface, not on a connector, terminal or bare conductor. Wrinkles, bubbles, exposed conductor or end lift are reject conditions and must be reworked.

Inspection and batch release: how to judge

The first piece checks tape type, width, layer count, overlap, direction and branch fixing; audit the same locations during patrol inspection. Keep the first piece, tape lot and rework record with the batch record. For custom assemblies, see custom wire harness manufacturing.

Get a Quote Back to List