Cable tie pull-out and clip retention verification: sampling, fixtures, loading and judgement
Test boundary: what is verified and what is not
This test verifies the retention of a cable tie around a harness section and the retention of a clip in its slot. It does not verify tie material ageing, long-term vibration life of clips or full-vehicle road profiles, and it does not replace the drawing's confirmation of fixing-point positions. The test only answers whether the fixing stays within the judgement limit for this sample, this fixture and this loading direction; a single result is not extended to other specifications.
Sampling: ties, clips and harness sections from the same batch
Samples are taken from the same batch of ties, the same batch of clips and the same length of harness, and the batch number, specification, production date and harness outside diameter are recorded. The harness section is prepared in its actual tied condition, including the actual number of conductors and the outer covering; clip samples include the slot or a simulated slot whose dimensions match the drawing. The number of specimens follows the sampling plan and is not replaced by “a few taken at hand”.
Tie pull-out test: clamping, loading direction and speed
Fix the harness section in the fixture, install the tie at its actual tied position, and keep the clamping point away from the tie head and the cut end. Load in the direction opposite to the tie take-up direction and set the speed according to the test specification; record the onset of slip, visible displacement and complete release. Do not push or pull the harness by hand during the test, and while reading the force, watch whether the tie rolls over and whether the clip is loaded.
Clip retention test: slot fit, pull-out and lateral loading
Seat the clip in a slot that matches the actual part, first perform the pull-out test and then the lateral retention test; when required, repeat assembly and removal according to the specification and observe whether the clip spring takes a permanent set. The loading direction follows the actual force direction of the clip in the vehicle or equipment, and the fixture must not cover the clip release feature. After each assembly and removal, inspect the clip appearance and slot edge; stop and record on any crack, whitening or permanent deformation.
Judgement and batch disposition: limits, records and isolation
Judge against the limit given by the drawing or test specification; “it did not come off immediately” is not a pass. Record the specimen number, batch, loading direction, maximum force, failure mode and test conditions. If the limit is exceeded, release occurs early or the clip deforms, isolate the batch and retest with tightened sampling. If the retest still fails, stop the batch from going online and trace the tie, clip and harness-section sources; the test report states only measured values and the judgement, never an unverified life claim. More verification requirements are in cable tie and clip fixing process.