Tape adhesion and holding power test: initial tack, holding and end lift
Test scope: what adhesion and holding power measure
Initial tack is whether the tape grips immediately; holding power is whether it resists creep under sustained load; peel strength is the force needed to remove it. These are separate properties. Before testing, record tape type, lot, adherend and surface cleanliness.
Initial tack: sampling and judgment
Take a representative strip from the same roll and apply it to the material specified on the drawing with the specified pressure and dwell. Judge against the customer specification or applicable method, and record temperature, humidity and pressure. Results from different surfaces are not directly comparable.
Holding and peel: load and time
Apply the specified mass for holding power and record slip or failure time; peel at a fixed angle and speed and record force. Define specimen count, load position and stop criteria before the test, so a single good result is not picked out.
End lift: causes and judgment
End lift usually comes from too short a finish, oil on the surface, uneven tension or a thick tape. Check that the finish lands on the tape, clears connectors and moving parts, and record lift height or length after the specified observation time.
Batch and line release: records and approval
Record tape type, lot, shelf life and test result at goods receipt; check the roll number against the first piece before issue. Quarantine failing lots and do not release them to the line; resample after rework. For the wrapping process, see tape wrapping process.